![]() ![]() Check the Z encoder readings in the sensor check menu. Next check and see if there is dust in the Z encoder that is causing it to lose track of position.Rapidly move the Z truck up and down seeing if you can get the belt to skip on the pulley or within the clamp that holds the belt onto the back of the truck.Because of the spiral flutes, a loose bit will then to be pulled out of the adapter during carving. ![]() Make sure that the bit is held tightly in the bit adapter and the spindle.The situation can be revealed or made worse by high force operations like vector cuts with large bits. The machine can unexpectedly begin to carve deeper as the carving progresses.Ĭauses include: a loose bit, dust in the Z encoder, a loose Z belt clamp on the back of the Z-truck, or a loose encoder wheel on the Z motor. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
August 2023
Categories |